Manual / How To
Send messages to the Operator Screen
OpenFollow can show short text cards on the Operator Screen – a standby, the next cue, a note for whoever is on a given marker – pushed in over OSC from a console or show-control system. This guide covers sending them from QLab, grandMA3, and ETC Eos. For placement, routing, scale, replace-versus-stack behaviour, and clearing, see Operator Messages.
Cards arrive on the same receiver as OSC Input. Before any tab below will work:
- Tick Input → OSC Input → OSC server (Listen for OSC messages) and note its UDP Port (default
8765). - Tick Input → Operator Messages → Operator messages (off by default).
- Add the sender's IP to Allowed sender IPs.
Send to the /message address with up to four arguments – the main line, an optional second line, the marker ID to route by, and an auto-dismiss time in seconds:
/message <message> <info> <markerId> <seconds>
Marker ID 0 broadcasts to every station; 1 or higher shows only on the station controlling that marker (with Routing on Only the marker's station, the default) and replaces that marker's earlier card; broadcast cards stack. Text is cut at 200 characters per field. 0 seconds keeps the card until cleared with /message/clear. The full argument reference is in Operator Messages and the OSC Dictionary.
No station IPs needed. Point the console at OpenFollow's OSC Input Multicast group (default 239.20.20.20) on port 8765 instead of each station's address, and every station receives the message at once. Marker routing still decides which station shows the card. Use this destination in any tab below.
Sending from a console
Each example sends the same card – "Standby downstage" over "Q 51", to the operator on marker 3, clearing after 8 seconds.
- Add a network patch pointing at OpenFollow's IP and OSC Input port (
8765), set to send an OSC message. - Add a Network cue on that patch.
- In the cue's message field, type the OSC command. QLab quotes strings that contain spaces; bare digits are integers, digits with a decimal point are floats:
/message "Standby downstage" "Q 51" 3 8.0
See QLab's Network Cues reference.
- Add OpenFollow as an OSC destination under Menu → In & Out → OSC (its IP and OSC Input port
8765). Note the destination number. - Fire the card from a macro or cue with
SendOSC. The message string groups the type tags (ssif), then the values:
SendOSC 1 "/message,ssif,Standby downstage,Q 51,3,8.0"
1 is the OSC destination number from step 1. Keep commas out of the text – SendOSC uses them to separate fields. This is the same path used to drive markers in OSC Input → grandMA3.
- Enable OSC TX and add OpenFollow as a destination under Setup → System → Show Control → OSC (its IP and OSC Input port
8765). - Send the card from a macro with
{Send_String}, in Eos's address=comma-separated args format. Quote strings that contain spaces:
Send_String /message="Standby downstage","Q 51",3,8.0
Or send it from a cue: select the cue, press {Execute}, then {String}, and type the same OSC string. See ETC's OSC with Eos.